
6) Installation Instructions (Rim and SecureBolt™)
Cover
Trim Assembly
Tailpiece
must be
in vertical
position
B
C
A
A
(2) Finish Washers
Head Screws
B
Solenoid Wire
Harness
Trim
Gasket
CAUTION
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
(2) 1/4 - 20 Oval
8
(2) 1/4 - 20 Pan
Head Screws
TRIM GASKET APPLICATION:
Peel off the adhesive protective paper
from gasket. Feed Trim assembly solenoid
wire harness through gasket opening as
shown and firmly press gasket to
escutcheon, aligning edge of gasket with
the edge of the escutcheon.
Inside
of
Door
6.4) Installation of Outside Trim and Exit Device
Outside Trim Assembly
1. Seal device against door being careful to align vertical trim tailpiece to
engage with cross hole of device cam.
2. Fasten device to trim assembly through holes “B” using (2) 1/4 – 20 pan head screws.
3. Follow instructions packed with device to secure device to door. Tighten all screws.
2 Pin
Methode
Solenoid
8 Pin
Molex
Doorwire
2 Pin
Molex REX
Comentarios a estos manuales