Assa Abloy 9M800 TCNE1 Series Especificaciones descargar pdf (Pagina 16)

7) Installation Instructions (Mortise)

7.4) Installation of Outside Trim and Exit Device

Outside Trim Assembly

Cover

Solenoid

Wire Harness

“B”

“A”

“B”

“A”

Device

Finger

(2) 1/4-20

Pan Head Screws

Trim

Gasket

TRIM GASKET APPLICATION:

Peel off the adhesive protective paper

from gasket. Feed Trim assembly solenoid

wire harness through gasket opening as

shown and firmly press gasket to

escutcheon, aligning edge of gasket with

the edge of the escutcheon.

8 Pin

Molex

Doorwire

2 Pin

Methode

Solenoid

2 Pin

Molex REX

1. For exterior door applications, it is recommended that the gaskets

provided be applied as shown.

2. Route the 2 pin REX (Request to Exit) connector harness into the Trim Assembly

cavity in the door and up thru the door and out the 1/2” diameter Hole “C”.

3. Route the Trim Assembly 2 pin connector of the Solenoid wire harness into the trim

assembly cavity in the door and out the 1/2” diameter hole “C”. Be careful not to

pinch any wire harness wires.

4. Mount trim assembly to door through holes “A” using (2) 1/4” – 20 oval head

screws and (2) finish washers. Finger tight only!

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Sin comentarios

Assa Abloy 9M800 TCNE1 Series Especificaciones Pagina 16