Assa Abloy 9M800 TCNE1 Series Especificaciones descargar pdf (Pagina 8)

6) Installation Instructions (Rim and SecureBolt™)

Cover

Trim Assembly

Tailpiece

must be

in vertical

position

(2) Finish Washers

Head Screws

Solenoid Wire

Harness

Trim

Gasket

CAUTION

DOOR MUST REMAIN OPEN

DURING INSTALLATION.

USE DOOR STOP.

(2) 1/4 - 20 Oval

(2) 1/4 - 20 Pan

Head Screws

TRIM GASKET APPLICATION:

Peel off the adhesive protective paper

from gasket. Feed Trim assembly solenoid

wire harness through gasket opening as

shown and firmly press gasket to

escutcheon, aligning edge of gasket with

the edge of the escutcheon.

Inside

Door

6.4) Installation of Outside Trim and Exit Device

Outside Trim Assembly

1. For exterior door applications, it is recommended that the Trim Gasket

(provided) be applied as shown below.

2. Route the 2 pin REX (Request to Exit) connector harness into the Trim Assembly cavity in

the door and up thru the door and out the 1/2” diameter Hole “C”.

3. Route the Trim Assembly 2 pin connector of the Solenoid wire harness into the trim

assembly cavity in the door and out the 1/2” diameter hole “C”. Be careful not to pinch any

wire harness wires.

4. When mounting trim, lift tailpiece to pass through hole on device side. Be sure tailpiece is

in vertical position.

5. Fasten trim assembly through holes “A” using (2) 1/4” – 20 oval head screws and (2) finish

washers. Finger tight only!

8 Pin

Molex

Doorwire

2 Pin

Methode

Solenoid

2 Pin

Molex REX

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Comentarios a estos manuales

Sin comentarios

Assa Abloy 9M800 TCNE1 Series Especificaciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Controladores De Puerta De Seguridad Assa Abloy 9M800 TCNE1 Series