Assa Abloy 9M800 TCNE1 Series Especificaciones descargar pdf (Pagina 18)

7) Installation Instructions (Mortise)

GASKET APPLICATION:

Peel off the adhesive protective paper from

gasket. Feed Keypad ribbon cable and ground

wire through gasket opening as shown and firmly

press gasket to escutcheon, aligning edge of

gasket with the edge of the escutcheon.

Ground Wire

Keypad Ribbon Cable

Outside

Door

Fire Stop Plate

Gasket

(optional)

7.5) Installation of Cylinder and Outside Keypad Escutcheon

Cylinder Installation

Note: For devices without cylinders, skip this section.

1. Back cylinder set screw out of Mortise Lock.

2. Insert cylinder through trim assembly and thread into Mortise Lock until cylinder is flush with

escutcheon. Keyway should be vertical with plug toward lever.

3. Tighten cylinder set screw.

4. Assemble Mortise Lock armor front with (2) screws.

5. Tighten all screws for lock, trim assembly and exit device.

Outside Keypad Escutcheon

2a. For fire rated devices, feed keypad ribbon cable/connector and ground wire from outside of

door through fire stop plate and hole in door.

2b. For non fire rated exit devices, feed keypad ribbon cable/connector and ground wire through

hole in door.

3. Place escutcheon against door surface.

Armor

Front

1. For exterior applications, it is recommended that the Trim Gasket (provided) be applied

as shown.

Cylinder Set Screw

1 2 ... 13 14 15 16 17 18 19 20 21

Sin comentarios

Assa Abloy 9M800 TCNE1 Series Especificaciones Pagina 18